|
Installation
|
| |
|
|
| |
 Step A: Clean mounting area thoroughly. Outline guard on wall and inside flat surface of tub with pencil. |
Step B: Remove bottom section from guard and expose adhesive. Carefully place against wall and top of tub inside pencil outline. |
 Step C: Expose adhesive on top section. Holding away from wall, place front edge into bottom section. Press down into bottom section while pushing back to pencil outline on wall.
|
|
Caulking Around Guards Is Recommended
To install in radius corner; saw off square corner of guard, install as above & caulk.
|
|
|
|
| |
| Step A: Clean and dry thoroughly the area where mini-Spraymaid is to be applied. |
 Step B: Before exposing adhesive backing, place guard in desired position and mark with pencil. Check surface for excess caulking or interference. |
Step C: Remove paper liner from adhesive. Place in position on penciled marks carefully making contact with wall and top of tub at same time. |
| Step D: Due to irregularities in some tub and wall installations, caulking may be desired. |
| |
|
Caulking Around Guards Is Recommended
To install in radius corner; saw off square corner of guard, install as above & caulk.
|
|
|
